Best quality oils and greases


«OLEOTON» HotTemp — lubricant is specially designed for the needs of the metallurgical industry. Increased operating temperature and the temperature of dropping point of grease enable the use of «OLEOTON» HotTemp in bearing and other units of the metallurgical equipment, where other lubricants burn, flows or lose their lubricating properties.

Main aggregates, in which the use of «OLEOTON» HotTemp is recommended are:

  • furnace roller conveyors;
  • pushers of continuous furnaces,
  • section of secondary cooling of CCM;
  • slag;
  • domain and rolling equipment.

Like all «OLEOTON» lubrication, «OLEOTON» HotTemp provides a cost reduction of enterprises on maintenance and repair of the equipment.

More information


NLGI: 2-3

Temperature Range



Appearance, physical state, colorHomogeneous grease, color from light red to red
Drop point, not lower than, °C310
Viscosity at −20 °C with an average gradient of a strain rate 10 s-1, Pa*s, not more than1800
Mass fraction of solids, %, not more thanNone
Colloidal stability, % of separated oil, not more than8
Evaporation at 120 °C for 1 hour, %, not more than5
Oxidation stability, mgKOH/g, not more than5
Corrosion effect on metalsResists
Protective propertiesSustains
Water resistance at 79 °C for 1 hour, %, not more than5
4-Ball wear test (at 20±5 °C), N, not lower than
— Welding point3480
— Failure load1040
— 40 kg scar, mm0,6
Copyright MAXXmarketing Webdesigner GmbH


Address: 12, Malynska st, Kyiv, Ukraine
Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Working hours: Mon-Fri 09:00-18:00